1/3" Interline Progressive CCD Square/Cube Type Monochrome Camera
|
|
By: Sentech
Industrial, USB, & Medical Cameras
|
The Sentech STCRCL33AC3 is a full-featured, remote head, cost effective, VGA, progressive scan digital Camera Link� cube camera with a 1/3" monochrome CCD.
STC RCL33A C3
→ 1/3" CCD Image Sensor
→ VGA, Progressive Scan, 90fps
→ Cubed Remote Head Type
Imager | 1/3” Interline VGA Monochrome Progressive CCD: ICX424AL
|
Total Picture Element | 692 (H) x 504 (V)
|
Active Picture Element | 648 (H) x 494 (V)
|
Chip Size | 7.4 (H) x 7.4 (V) mm
|
Cell Size | 5.79 (H) x 4.89 (V) μm
|
Scanning System | Progressive
|
Scanning Method | Full, Partial full, 1/2 partial, 1/4 partial, Variable partial, Binning (Partial, 1/2 partial, 1/4 partial, Variable partial)
|
Vertical Frequency (Frame Rate) | 94.784 Hz
|
Horizontal Frequency | 47.2028 kHz
|
Pixel Frequency | 36.8181 MHz
|
S/N Ratio - @ 8bit output | ≤ 3 Digit (Gain 0 dB)
|
S/N Ratio - @ 10bit output | ≤ 10 Digit (Gain 0 dB)
|
Minimum Scene Illumination | 0.11 Lux at F1.2
|
Sync System | Internal / External
|
Video Output | Digital 8 or10 bit CameraLink® (Base Configuration)
|
Tap | 1 Tap
|
Shutter Speed | OFF, ½ to 1/100,000 sec. (Variable at every H and clock)
|
Gain | 0 to 27 dB
|
Gamma | 1.0
|
Power - Input Voltage | 12 Vdc ± 10%
|
Power - Consumption | < 3.5 W
|
Trigger Mode | Edge Preset Trigger (V-reset, Non-reset); Pulse Width Trigger (V-reset, Non-reset)
|
Communication | RS232 via Camera Link connector
|
Dimensions - CCU | 28 (W) x 28 (H) x 36.5 (D) mm (not including connector)
|
Dimensions - Head | 17 (W) x 17 (H) x 16.9 (D) mm
|
Optical Filter | No IR cut filter
|
Optical Center Accuracy | Positional accuracy in H and V directions: /0.31 mm Rotational accuracy of H and V: /2.1 deg.
|
Material - Case | Front, base, and rear: Aluminum die cast (ADC 12) Cover: Steel sheet covered with zinc
|
Material - Tripod | Polycarbonate ABS
|
Lens Mount | M10.5 (P = 0.5) (Male screw)
|
Interface Connector | HR 10A-7R-6PB (Hirose) or equivalent
|
Tripod | Tripod can be attached to 4 plates (4 screws on the bottom plate, 3 screws on the other 3 plates)
|
Weight | Approximately 150g
|
Temperature and Humidity - Operating | Temperature: -5 to 50 deg. C; Relative Humidity: 0 to 85% (No condensation)
|
Temperature and Humidity - Storage | Temperature: -30 to 65 deg. C; Relative Humidity: 0 to 90% (No condensation)
|
Vibration | 10 Hz to 150 Hz, 0.35 half amplitude (Maximum acceleration 50 m/s2); 3 directions 8 times each
|
Shock | Acceleration 150 m/s2, 6 directions 10 times each
|
Standard Compliancy | EN61326; 1997/AnnexA A1, 1998 (EMI: Class B) A2: 2001
|
RoHS | RoHS Compliant
|
© 1996 - 2024 | All Rights Reserved
Audio Video Supply Inc.
4542 Ruffner St. Suite 220
San Diego, CA 92111
Prices and specifications subject to change without notice.