Supplying Wholesale Markets • OEM Solutions • Extensive Product Range

Cardioid Microflex Lavalier Microphones

By: Shure

shure microphones, headphones, wireless systems

Microphones, Headphones & Wireless systems

Shure : MX185

Description

The Shure Microflex Microphone Series
MX 185 bring a new level of sophistication to personal voice reproduction. Like all Microflex family microphones,
the MX-185 Lavaliers use Shure’s interchangeable condenser cartridges, available in cardioid, supercardioid or omnidirectional polar patterns. That means you can be sure there is a Microflex Lavalier that’s right for your application. Compatible with all Shure wireless bodypack transmitters, their high sensitivity and wide frequency response guarantee great sound.


Features

→ Wide dynamic range and frequency response for accurate sound reproduction
→ Interchangeable cartridges that provide a choice of polar pattern for each application
→ Rotatable tie-clip that pivots in 90° increments for placement flexibility
→ Dual tie-clip and belt-clip preamp
→ Supplied with snap-fit foam windscreen that controls breath noise
→ Balanced, transformerless output for increased immunity to noise over long cable runs
→ RF filtering

Specifications

Type Condenser (electret bias)
Frequency Response 50–17000 Hz
Polar Pattern MX183= Omnidirectional; MX185= Cardioid; MX184= Supercardioid
Output Impedance EIA Rated at 150 o (180 O actual)
Output Configuration Active balanced
Sensitivity (at 1 kHz , open circuit voltage) Cardioid= –35 dBV/Pa (18 mV); Omnidirectional= –28 dBV/Pa (42 mV); Supercardioid= –34 dBV/Pa (21 mV); 1 Pascal=94 dB SPL
Maximum SPL (1 kHz at 1% THD, 1 kO load) Cardioid= 124 dB; Omnidirectional= 117 dB; Supercardioid= 123 dB
Equivalent Output Noise (A-weighted) Cardioid= 28 dB SPL; Omnidirectional= 21 dB SPL; Supercardioid= 27 dB
Signal-to-Noise Ratio (referenced at 94 dB SPL at 1 kHz) Cardioid= 66 dB; Omnidirectional= 74 dB; Supercardioid= 68 dB
Dynamic Range (1 kO load at 1 kHz) 96 dB
Common Mode Rejection (10 Hz–100 kHz) 45 dB minimum
Preamplifier Output Clipping Level (1% THD) –6 dBV (0.5 V)
Polarity Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
Environmental Conditions Operating Temperature= -18–57 °C (0–135 °F); Storage Temperature= -29–74 °C (-20–165 °F); Relative Humidity= 0–95%
Power Requirements 11–52 Vdc phantom, 2.0 mA
Cable 1.2 m (4 ft)