Supplying Wholesale Markets • OEM Solutions • Extensive Product Range

NVT : NV-4PS10-PVD

4 Channel Power Supply Cable Passive Integrator Hub

By: NVT

nvt utp and transceivers

Video/Power transmission Solutions

Description

The NVT 4 Channel Power Supply Cable Passive Integrator Hub NV-4PS10-PVD combines a 1 Amp/channel power supply with pass through video and telemetry data, for up to 4 cameras, all over UTP wire. Designed for installation in the wiring/IDF telecom closet, or at the Control/MDF room, the NV-4PS10-PVD consolidates connectivity vial standard 4-pair RJ45 EIA/TIA 568B compliant premises wiring and pinouts.

At the camera, Power, Video and Data connections are made using a PVD transceiver via an RJ45 connector and a single 4-pair cable. Control/MDF room connections are achieved with a single 4-pair RJ45 cable for each group of four cameras. P/T/Z telemetry data, if required, passes through the NV-4PS10-PVD data path and is connected to the controller via a second 4-pair RJ45 cable.
 

Features

NV-4PS10-PVD features include:

→ Each output is individually thermistor protected.
→ Provides Class 2 SELV camera power and pass-through video and telemetry data connectivity for up to 4 cameras, each via a single RJ45 4-pair UTP cable
→ Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
→ Independently selectable 24 or 28VAC with 1 Amp max per channel
→ Automatic-reset fault protection; transient protection
→ Individually floating outputs ensure total ground-loop immunity
→ Frequency response DC to 10MHz (see Recommended Distance Chart)
→ Diagnostic LEDs show load/no load, miswires, and overload conditions
→ Use with the NV-216A-PV or NV-218A-PVD transceivers or the NV-226J-PV transmitter at the camera
→ Power cameras via UTP over significant distances (see Power Distance Chart) 1.75” high x 7.25” deep x 9.25” wide, wall or desk mount
→ Limited lifetime warrant

Specifications

Camera Power Each camera is powered by a fully isolated (floating) Class 2 SELV output, individually switchable 24VAC / OFF/ 28VAC at up to 1 Amp.
Power inlet IEC with molded power cord (included)
Power Input On-off switch Rear panel
Power Input Voltage 115 / 230 VAC
Power Input Current 1.25 / 0.625 Amps
Power Input Frequency 50 / 60 Hz
Power Input Protection 2.5A slo-blo 8x20mm fuse and thermal shutdown
Power Input Wattage 125 Watts
Power Input Heat (power supply only) 50 BTU/hour (power supply with cameras) 420 BTU/hour
Blue LED System power on
Per-channel LED indicates Off No load connected
Per-channel LED indicates Green Load connected and working
Per-channel LED indicates Amber Mis-wiring detected
Per-channel LED indicates Red Overload shutdown condition
Ambient Temperature -4 to 122 °F (-20 to 50 °C)
Minimum airflow 4 ft3/min (0.1m3/min)
Humidity (non-condensing) 0 to 95%
Transient Immunity per ANSI 587 C62.41
Dimensions 9.25in wide, 1.75in high, 7.25in deep
Including connectors (235mm wide, 44,5mm high, 184mm deep)
Weight 7lb (3,2kg)
Mounting Wall, or desk mount

 

Resources & Documents

nv-4ps10-pvd.pdf Datasheet